GNUK 1.2.15 on XNUCLEO-F103RB does not respond to gpg --card-status

Szczepan Zalega | Nitrokey szczepan at nitrokey.com
Wed Feb 3 13:28:40 CET 2021


On 2/3/21 1:08 PM, Mike wrote:
> I ran ./configure --vidpid=234b:0000 --enable-factory-reset --target=ST_NUCLEO_F103 
> 
> What should I look at to make the board work?

1. How is your USB connected to the board? What pins do you use?
2. Are there any dmesg messages from the USB connection (USB enumeration)?

(I am sorry, if I am making obvious questions)

-- 
Best regards,
Szczepan



More information about the Gnuk-users mailing list