GNUK 1.2.15 on XNUCLEO-F103RB does not respond to gpg --card-status

Mike mishaad051 at
Wed Feb 3 16:33:29 CET 2021

J1 is on the contacts. I attempted to replace the jumper. After
replacing the jumper, I reset the board. Still, dmesg is oddly silent.
As is GPG. I used the memory inspector from STCUBE (the GNUK was not
personalized yet) and bits of gnuk.elf in range 0x0 - 0x3F0 and the bits
of controller in same range are the same.

More information about the Gnuk-users mailing list