<div dir="auto">Hi there,<div dir="auto"><br></div><div dir="auto">I am new to Gnuk so forgive me if this is a newbie mistake...</div><div dir="auto"><br></div><div dir="auto">I have successfully built and programmed Gnuk onto a ST-Link V2 clone (target=ST_DONGLE). I have programmed it with OpenOCD using another ST-Link V2 :) it works.</div><div dir="auto"><br></div><div dir="auto">However it now seems that the SWD interface on the Gnuk target board is disabled so I can't connect with OpenOCD to reprogram it. OpenOCD behaves as if I'm not plugged into any device.</div><div dir="auto"><br></div><div dir="auto">Is this by design? I assume it might be, to close this off as a vector of attack. Is there a way to open it back up? I don't mind losing the key I've generated on it as this is just experimental so far.</div><div dir="auto"><br></div><div dir="auto">Thanks,</div><div dir="auto"><br><div data-smartmail="gmail_signature" dir="auto">--<br>Patrick "Trick" van Staveren<br><a href="http://trick.vanstaveren.us/">http://trick.vanstaveren.us/</a></div></div></div>