Pinpad support for REINER SCT cyberJack go

[Alina Friedrichsen]

Now I have all dependencies to run "./configure",
but "make" breaks with the following error message:

make[2]: *** No rule to make target `audit-events.h', needed by `all'.  Stop.
make[2]: Leaving directory `/home/x-alina/Downloads/gnupg/common'

-------- Original-Nachricht --------
> Datum: Wed, 06 Mar 2013 15:14:26 +0900
> Von: NIIBE Yutaka <gniibe at fsij.org>
> An: Alina Friedrichsen <x-alina at gmx.net>
> CC: gnupg-devel at gnupg.org
> Betreff: Re: Pinpad support for REINER SCT cyberJack go

> On 2013-03-06 at 04:24 +0100, Alina Friedrichsen wrote:
> > I use GnuPG 2.0.19, build from source.
> 
> In 2.0.19. pinpad input is not supported through PC/SC.
> 
> The pinpad input feature for PC/SC has been added both of master and
> STABLE-BRANCH-2.0.  You will be able to use it with forthcoming
> 2.0.20.  (You will need to add enable-pinpad-varlen option for
> ./gnupg/scdaemon.conf.)
> 
> > lsusb:
> > ID 0c4b:0504 Reiner SCT Kartensysteme GmbH 
> > 
> > gpg2:
> > gpg: detected reader `REINER SCT cyberJack go (4603989351) 00 00'
> 
> I got a report that following card reader works fine:
> 
>   0c4b:0500 Reiner SCT Kartensysteme GmbH
>   "REINER SCT cyberJack RFID standard (7592671050) 00 00"
> 
> Since it seems that your reader is newer than that, I hope that it
> works well, too.
> 
> Besides, for both of master and STABLE-BRANCH-2.0, internal CCID
> driver got improved.  I think that you can use your reader without
> PC/SC.  If it works, it is better for your reader to be added
> to good readers list of enable_varlen=1 in scd/ccid-driver.c
> so that you don't need to configure.
> 
> If you have enough time, please try STABLE-BRANCH-2.0 of
> git.gnupg.org.  Or else, please wait for 2.0.20.
> -- 
> 
>