Aw: Re: Pinpad support for REINER SCT cyberJack go

[Alina Friedrichsen]

I build a zombie version GnuPG 2.0.19 with the scdaemon from the stable git.

And yes, I can confirm signing with pinpad doesn't work with this reader, too.

> Gesendet: Sonntag, 10. März 2013 um 13:50 Uhr
> Von: "Alina Friedrichsen" <x-alina at gmx.net>
> An: "NIIBE Yutaka" <gniibe at fsij.org>
> Cc: gnupg-devel at gnupg.org
> Betreff: Aw: Re: Pinpad support for REINER SCT cyberJack go
>
> With both ways the pinpad does not work.
>
> I could only test the --card-edit commands.
> Importing my GnuPG-Card into the secret key ring does not work.
> So I can't test decryption and signing.
>
> Any ideas?
>
> > Gesendet: Mittwoch, 06. März 2013 um 07:14 Uhr
> > Von: "NIIBE Yutaka" <gniibe at fsij.org>
> > An: "Alina Friedrichsen" <x-alina at gmx.net>
> > Cc: gnupg-devel at gnupg.org
> > Betreff: Re: Pinpad support for REINER SCT cyberJack go
> >
> > On 2013-03-06 at 04:24 +0100, Alina Friedrichsen wrote:
> > > I use GnuPG 2.0.19, build from source.
> >
> > In 2.0.19. pinpad input is not supported through PC/SC.
> >
> > The pinpad input feature for PC/SC has been added both of master and
> > STABLE-BRANCH-2.0.  You will be able to use it with forthcoming
> > 2.0.20.  (You will need to add enable-pinpad-varlen option for
> > ./gnupg/scdaemon.conf.)
> >
> > > lsusb:
> > > ID 0c4b:0504 Reiner SCT Kartensysteme GmbH
> > >
> > > gpg2:
> > > gpg: detected reader `REINER SCT cyberJack go (4603989351) 00 00'
> >
> > I got a report that following card reader works fine:
> >
> >   0c4b:0500 Reiner SCT Kartensysteme GmbH
> >   "REINER SCT cyberJack RFID standard (7592671050) 00 00"
> >
> > Since it seems that your reader is newer than that, I hope that it
> > works well, too.
> >
> > Besides, for both of master and STABLE-BRANCH-2.0, internal CCID
> > driver got improved.  I think that you can use your reader without
> > PC/SC.  If it works, it is better for your reader to be added
> > to good readers list of enable_varlen=1 in scd/ccid-driver.c
> > so that you don't need to configure.
> >
> > If you have enough time, please try STABLE-BRANCH-2.0 of
> > git.gnupg.org.  Or else, please wait for 2.0.20.
> > --
> >
> >
> >
>
> _______________________________________________
> Gnupg-devel mailing list
> Gnupg-devel at gnupg.org
> http://lists.gnupg.org/mailman/listinfo/gnupg-devel
>