Anyone have hpux11.11 gnupg working?

[Christoph Moench-Tegeder]

## Furnish, Trever (tgfurnish@herff-jones.com):

> This is probably because I'm doing something patently stupid, but when I 
> run configure on HPUX11.11 on an rp8400, I get the following errors, 
> then configure dies:
> 
> # ./configure --prefix=/opt/gnupg
> checking build system type... config.sub: too many arguments
> Try `config.sub --help' for more information.
> configure: error: /bin/sh scripts/config.sub hppa2.0w-hp-hpux11.11 failed

It seems as if your /bin/sh is acting strange. The error above should
be observed if (and only if) config.sub is called with more than one
argument (ll. 108 in config.sub).
However, I can't reproduce your problem with hppa2.0w-hp-hpux11.00.

> Do I need a Gnu toolchain installed even just to run configure?  Any 
> pointers on where to start (what to check, what to update, what Gnu 
> tools required, how to tell configure about them once they're installed, 
> etc) would be greatly appreciated.

I was not able to compile gnupg 1.2.1 with HP's cc, there were some
issues with undefined symbols wich went away when switching to gcc.

configure can be influenced by setting some environment variables, e.g.
CC=gcc for using gcc as compiler.

Regards,
cmt

-- 
Spare Space